Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

348 Fabric OS Message Reference
53-1001767-01
FW-1501
42
FW-1501
Message <timestamp>, [FW-1501], <sequence-number>,, INFO, <system-name>, Mail overflow
cleared -
<Mails discarded> alerts discarded.
Probable Cause Indicates that the mail overflow condition has cleared.
Recommended
Action
No action is required.
Severity INFO
FW-1510
Message <timestamp>, [FW-1510], <sequence-number>,, INFO, <system-name>, <Area string>
threshold exceeded: Port <Port number> disabled.
Probable Cause It means port has been fenced because port has violated CRC, ITW, PE, C3TX_TO, ST, and LR high
thresholds.
Recommended
Action
Check for concurrent loss of synchronization errors. Check the SFP and the cable. Then enable the
port using the portEnable command.
Severity INFO
FW-1511
Message <timestamp>, [FW-1511], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, has crossed lower threshold boundary to in between(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the number of link failures that the port experiences has changed and crossed lower
threshold boundary to a value within the acceptable range. Link loss errors occur when a link
experiences a loss of signal and fails. Both physical and hardware problems can cause link loss
errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss
of synchronization errors and, if applicable, troubleshoot them.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1512
Message <timestamp>, [FW-1512], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, has dropped below upper threshold boundary to in between(High=<High
value>, Low=<Low value>). Current value is <Value> <Unit>.