Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

664 Fabric OS Message Reference
53-1001767-01
ZONE-1030
111
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
ZONE-1030
Message <timestamp>, [ZONE-1030], <sequence-number>,, WARNING, <system-name>, Converting
the zone db for PID format change failed.
Probable Cause Indicates the current zone database could not be converted to reflect the PID format change. Most
likely this is caused by the size of the zone database.
Recommended
Action
Change the PID format back to its original format. Reduce the size of the zone database. Then you
can change the PID format to the requested format.
Severity WARNING
ZONE-1031
Message <timestamp>, [ZONE-1031], <sequence-number>,, ERROR, <system-name>, Switch is in
interop mode. (switch, port) members not supported.
Probable Cause Indicates the switch is set to interop mode using the interopMode command. Interop mode does
not allow <domain, portarea> members in the active zone database.
Recommended
Action
Remove all <domain, portarea> members from the zone database, or convert them to world wide
name (WWN) zoning.
Severity ERROR
ZONE-1032
Message <timestamp>, [ZONE-1032], <sequence-number>,, ERROR, <system-name>, Domain
<domain number> Max Zone DB size <max zone db size>.
Probable Cause Indicates the specified domain does not have enough memory for the zone database being
committed.
Recommended
Action
Reduce the size of the zone database and retry the operation.
Severity ERROR
ZONE-1033
Message <timestamp>, [ZONE-1033], <sequence-number>,, ERROR, <system-name>, Domain
<domain number> Lowest Max Zone DB size.