Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

Table Of Contents
Fabric OS Message Reference 739
53-1001767-01
Chapter
128
AUDIT SULB System Messages
SULB-1001
Message AUDIT, <timestamp>, [SULB-1001], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has started.
Probable Cause Indicates the firmwareDownload command has been started. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended
Action
No action is required. Allow the firmwareDownload command to continue without disruption. Do
not fail over or power down the system during firmware upgrade.
Run the firmwareDownloadStatus command for more information.
Severity WARNING
SULB-1002
Message AUDIT, <timestamp>, [SULB-1002], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has completed successfully.
Probable Cause Indicates the firmwareDownload command has completed successfully and switch firmware has
been updated.
Recommended
Action
No action is required. The firmwareDownload command has completed as expected.
Run the firmwareDownloadStatus command for more information. Run the firmwareShow
command to verify the firmware versions.
Severity INFO
SULB-1003
Message AUDIT, <timestamp>, [SULB-1003], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwarecommit has started.
Probable Cause Indicates that the firmwareCommit command has started.
Recommended
Action
No action is required. Run the firmwareDownloadStatus command for more information.
Severity INFO