director 2/64 installation guide

Using HAFM from a Remote Location
Use this section to install the HAFM client on a remote workstation.
Remote Workstation Minimum Requirements
The following minimum requirements must be met in order to install HAFM on a
remote workstation.
IMPORTANT: In order for HAFM to function properly, compatible versions must be installed on
both the client and server machines.
• Windows, UNIX or Workstation with color monitor, keyboard, and mouse using:
— Intel Pentium processor with a 200 MHz or greater clock speed, and the
Microsoft Windows 95, Windows
98, Windows ME, Windows 2000,
Windows NT 4.0, Windows XP, Unix, or Linux 2.2 operating system.
— Hewlett-Packard HA PA-RISC processor with a 360 MHz or greater clock
speed, using the HP-UX 11 or higher operating system.
— Sun Microsystems UltraPARC-II processor with a 300 MHz or greater clock
speed, using the SunOS Version 5.5.1 or higher operating system, or Solaris
Version 2.5.1 or higher operating system.
— IBM PowerPC microprocessor with a 233 MHz or greater clock speed, or
POWER3 microprocessor with a 333 MHz or greater clock speed, using the
AIX Version 4.3.3 or higher operating system.
• At least 15 MB available on the internal hard drive.
• 32 MB or greater RAM.
• Video card supporting 256 colors at 800 x 600 pixel resolution.
• Ethernet network adapter.
• Java-enabled Internet browser, such as Microsoft Internet Explorer (Version 4.0 or
later) or Netscape Navigator (Version 4.0 or later).
Install HAFM Client on a Remote Workstation
Use these steps to install HAFM on a remote client:
1. Verify the workstation and the Ethernet LAN segment (with the Director 2/64
attached) are connected through the Internet.
2. At the workstation, launch the browser application.