director 2/64 installation guide

director 2/64 installation guide 3–1
3
Using EWS to Configure
the Director 2/64
This chapter contains information on how to launch and configure the Embedded Web
Server. The configuration portion defines specific Director 2/64 system settings,
including:
•Ports
• Network addresses
• Identification and contact information
• Date and time
• Operating parameters
• SNMP settings
• Passwords and user privileges.
This chapter covers the initial set up of the Director 2/64. For additional information
regarding setting up zoning, zone sets, and SAN management in general, see the
online EWS help.
NOTE: Although products can perform normal operations without an HAFM server, the HAFM
server should operate at all times to monitor product operations, report failures, log event
changes, and log configuration changes.
Launch EWS
Use the following steps to launch EWS.
NOTE: Internet access and a standard Web browser is required. Hewlett-Packard
recommends Netscape Navigator 4.6 or higher, or Microsoft Internet Explorer 4.0 or higher.
1. Verify that the computer and Ethernet LAN segment (with the Director 2/64
attached) connect through the Internet.
2. Launch the browser application.