director 2/64 installation guide

director 2/64 installation guide 3–5
Using EWS to Configure the Director 2/64
Use the following steps to configure the director identification:
1. At the Configure page, click the Director tab. The Identification page displays,
as shown in Figure 3–4.
Figure 3–4: Identification page
a. Type a director name of 24 or fewer alphanumeric characters in the Name
field. Configure each director with a unique name.
If the director is installed on a public LAN, the name should reflect the
director’s Ethernet network DNS host name. For example, if the DNS host
name is SAN64.hp.com, the name entered in this dialog box is SAN64.
b. Type a director description of 255 or fewer alphanumeric characters in the
Description field.
c. Type the director’s physical location (255 or fewer alphanumeric characters)
in the Location field.
d. Type the name and phone number of a contact person (255 or fewer
alphanumeric characters) in the Contact field.
2. Click Activate to save the information. The message “Your changes to
the identification configuration have been successfully
activated” displays.