director 2/64 installation guide

3–6 director 2/64 installation guide
Using EWS to Configure the Director 2/64
Configure Date and Time
Use this procedure to configure the director date and time:
1. At the Configure page, click the Director tab, then choose the Date/Time tab.
The Date/Time Properties page displays, as shown in Figure 3–5.
Figure 3–5: Date/Time Properties page
a. Click the Date fields that require change. Type changes using the following
ranges:
Month (MM): 1 through 12
Day (DD): 1 through 31
Year (YYYY): greater than 1980
b. Click the Time fields that require change. Type changes in the following
ranges:
Hour (HH): 0 through 23
Minute (MM): 0 through 59
Second (SS): 0 through 59
2. Click Activate to save the information. The message “Your changes to
the date/time configuration have been successfully
activated” displays.