director 2/64 installation guide

3–8 director 2/64 installation guide
Using EWS to Configure the Director 2/64
4. Next, select the Configure option at the left side of the panel. The Configure page
opens with the Ports page displayed.
5. Click the Director tab, then click the Parameters tab. The Parameters page
displays, as shown in Figure 3–7.
Figure 3–7: Parameters page
Ordinarily, you do not need to change values in this page from their defaults. The only
exception is the Preferred Domain ID. Change this value if the director will
participate in a multiswitch fabric.
6. Use information under “Switch Parameters” to change settings as required for
parameters in this dialog box.
7. After you change settings, click the Activate button.
8. Return the director to online as follows.
a. At the View page, select the Operations option at the left side of the panel.
The Operations page opens with the Port Beaconing page displayed.
b. At the Operations page, click the Online State tab, then click Set Online.
The message “Your operations changes have been
successfully activated” displays.