director 2/64 installation guide

director 2/64 installation guide 3–11
Using EWS to Configure the Director 2/64
Configure Fabric Operating Parameters
Use procedures in this section to set parameters on the director for fabric operation
through the Fabric Parameters page. These operating parameters are stored in
NV-RAM on the director.
First, set the director offline as follows.
1. At the View page, select the Operations option at the left side of the panel. The
Operations page opens with the Port Beaconing page displayed.
2. At the Operations page, click the Online State tab. The Current State page
displays, as shown in Figure 3–6.
Figure 3–8: Current State page
3. Click Set Offline. The message “Your operations changes have
been successfully activated” displays.
4. Next, select the Configure option at the left side of the panel. The Configure page
opens with the Ports page displayed.
5. Click the Director tab, then click the Fabric Parameters tab. The Fabric
Parameters page displays, as shown in Figure 3–9.