director 2/64 installation guide

3–12 director 2/64 installation guide
Using EWS to Configure the Director 2/64
Figure 3–9: Fabric Parameters page
6. Use information under “Fabric Parameters” to change settings as required for
parameters in this dialog box.
7. After you change settings, click Activate.
8. Back up the configuration data when you are finished configuring the switch.
9. Return the director to online as follows.
a. At the View page, select the Operations option at the left side of the panel.
The Operations page opens with the Port Beaconing page displayed.
b. At the Operations page, click the Online State tab, then click Set Online.
The message “Your operations changes have been
successfully activated” displays.