director 2/64 installation guide

director 2/64 installation guide 3–15
Using EWS to Configure the Director 2/64
Configure Network Information
Verify the type of LAN installation with the customer’s network administrator. If one
director is installed on a dedicated LAN, network information (IP address, subnet
mask, and gateway address) does not require change.
If multiple directors are installed, or a public LAN segment is used, network
information must be changed to conform to the customer’s LAN addressing scheme.
Use the following steps to change a director’s IP address, subnet mask, or gateway
address:
1. Choose the Configure option at the left side of the panel. The Configure page
opens with the Ports page displayed.
2. At the Configure page, click the Director tab, then click the Network tab. The
Network page displays, as shown in Figure 3–10.
Figure 3–10: Network page
a. Type the new value as specified by the customer’s network administrator in
the IP Address field. (factory preset is 10.1.1.10)
b. Type the new value as specified by the customer’s network administrator in
the Subnet Mask field. (default is 255.0.0.0)