director 2/64 installation guide

director 2/64 installation guide 3–17
Using EWS to Configure the Director 2/64
Configure SNMP Trap Message Recipients
Use this procedure to configure community names, write authorizations, and network
addresses for up to 12 SNMP trap message recipients. A trap recipient is a
management workstation that receives notification (through SNMP) if a director event
occurs.
1. Launch EWS. See “Launch EWS” on page 3–1.
2. If network information was configured at the browser, go to step 3. If network
information was not configured, choose the Configure option at the left side of
the panel. The Configure page opens with the Ports page displayed.
3. At the Configure page, click the SNMP tab. The SNMP page displays, as shown
in Figure 3–12.
Figure 3–12: SNMP page
a. For each trap recipient, type a community name of 32 or fewer alphanumeric
characters in the associated Community Name field. The community name is
incorporated in SNMP trap messages to prevent unauthorized viewing or use.