director 2/64 installation guide

3–18 director 2/64 installation guide
Using EWS to Configure the Director 2/64
b. Click the check box in the Write Authorization column to enable or disable
write authorization for the trap recipient (default is disabled). A check mark in
the box indicates write authorization is enabled. When the feature is enabled,
a management workstation user can change sysContact, sysName, and
sysLocation SNMP variables.
c. Type the IP address or DNS host name of the trap recipient (SNMP
management workstation) in the associated Trap Recipient field. Use 64 or
fewer alphanumeric characters. Hewlett-Packard recommends using the IP
address.
d. The default UDP port number for trap recipients is 162. To override this port
number, click the Advanced option. The dialog box expands to show a UDP
Port Number column.
e. Type a decimal port number in the associated UDP Port Number field to
override the default value.
4. Click Activate to save the information. The message “Your changes to
the SNMP configuration have been successfully
activated” displays.
Configure User Rights
Use this procedure to configure the administrator-level and operator-level passwords
required to access EWS through the Username and Password Required page.
1. At the Configure page, click the User Rights tab. The User Rights page displays,
as shown in Figure 3–13.