director 2/64 installation guide

2–14 director 2/64 installation guide
Installing and Configuring the Director 2/64
1. Carefully lift the switch into the front of the rack and onto the shelf brackets and
slide the switch forward into the rack until the edge of the rear mounting plates are
approximately 1-inch from the rack’s rails, as shown in Figure 2–5.
2. Align one rear angle bracket with the cage nuts installed earlier, as shown in
“Insert the Cage Nuts” on page 2–13.
NOTE: Make sure that the angle bracket is in contact with the outside surface of the
mounting plate.
Figure 2–5: Aligning the switch in the rack
3. Loosely attach the rear angle bracket to the rack rail with the two panhead Phillips
screws provided, as shown in Figure 2–6.
4. Repeat step 2 and step 3 for the corresponding rear angle bracket, as shown in
Figure 2–6.
5. The two rear angle brackets now touch the outside surfaces of the rear mounting
plates. Slide the switch all the way into the rack to where the front mounting
bracket meets the rack rails.