director 2/64 installation guide

director 2/64 installation guide 2–15
Installing and Configuring the Director 2/64
6. If you are certain that the hardware lines up properly, secure the hardware as
follows:
a. Secure each rear mounting plate to the rear angle bracket with the two screws
provided.
b. Move to the front of the switch, and secure each front mounting bracket with
the three screws provided.
Figure 2–6: Securing the rear angle brackets
7. Using a torque driver, torque the screws to 22 in/lb.
8. Connect the remaining ends of the PDU power cords to separate PDUs (if
installed) as shown in Figure 2–7; otherwise, connect the two standard AC power
cords.
NOTE: Hewlett-Packard recommends installing an optional PDU in the rack.
Hewlett-Packard ships two PDU power cords with the Director 2/64.