director 2/64 installation guide

director 2/64 installation guide 2–21
Installing and Configuring the Director 2/64
b. Slide a sheet metal nut (2) on each of the located holes.
NOTE: Three sheet metal nuts should be on each front column face (3).
Figure 2–13: Preparing the front rack columns
2. Prepare the rear rack columns, as shown in Figure 2–14:
a. Standing at the back of the rack, count up from the top of the rail tray (1) to
12th and 28th on the rack’s back face.
b. Slide a sheet metal nut (2) on each of the located holes.
NOTE: Two sheet metal nuts should be on each back column face (3).