director 2/64 installation guide

2–22 director 2/64 installation guide
Installing and Configuring the Director 2/64
Figure 2–14: Preparing the rear rack columns
Prepare the Switch for Installation
The following section describes how to install the mounting hardware that attaches the
switch to the rails. This hardware includes:
• Two front mounting brackets
• Two rear mounting plates
• Eight 10-32, flat-head Phillips screws
Use these steps to secure the mounting hardware to the switch, as shown in
Figure 2–15:
1. Locate the two front mounting brackets in the shipping carton.
2. Position the front mounting bracket (5) so that the bracket’s angled side faces out
and is on the upper part of switch side.
3. Attach the bracket with 10-32, flat-head Phillips screws (4) using the two center
threaded holes on the front side of the switch.