director 2/64 installation guide

director 2/64 installation guide 2–23
Installing and Configuring the Director 2/64
4. Repeat step 2 and step 3 for the second front mounting bracket.
Figure 2–15: Installing the rack mounting brackets on the switch
5. Locate the two rear mounting brackets in the shipping carton.
6. Position a rear mounting bracket (3) so that the bracket’s center holes (1) line up
with the 1st and 3rd threaded holes on the back portion of the switch side.
IMPORTANT: The slotted end (2) of the bracket should face toward the back of the
switch.
7. Secure the rear mounting bracket to the switch using two 10-32, flat-head Phillips
screws.
8. Repeat step 6 and step 7 for the second rear mounting bracket.
Finalize the Rack Mounting Procedure
Use the following sections to complete the installation procedure.
After completing the steps outlined in the previous sections, install the switch in the
rack as follows.