director 2/64 installation guide

2–24 director 2/64 installation guide
Installing and Configuring the Director 2/64
WARNING: The Director 2/64 weighs approximately 115 pounds. Use proper
handling and lifting equipment to reduce the possibility of injury or product
damage.
1. Carefully position the switch in the front of the rack and onto the rail tray, and
slide the switch back on the rails until the front mounting brackets are against the
front rack columns.
Figure 2–16 illustrates using a lifting jack to position the switch.
NOTE: Hewlett-Packard recommends using the LIFT-O-FLEX 17000 SP 400 from R on I.
For more information, visit the R on I Web site at //www.roni.com/.
Figure 2–16: Positioning the switch in the rack
2. Mount the switch in the rack, as shown in Figure 2–17:
a. On one side at the back of the switch, position an angle bracket (2) so that the
threaded holes (1) are against the slots (5) of the rear mounting bracket and
the angled side face out.