director 2/64 installation guide

director 2/64 installation guide 2–31
Installing and Configuring the Director 2/64
3. After successful POST completion, the green power LED on the front bezel, green
LED on the active CTP2 card, and green PWR OK LEDs on both power supplies
remain O
N.
4. If a POST error or other malfunction occurs, refer to the hp StorageWorks director
2/64 service manual.
Configure Director Network Information
Use the following sections to configure the director’s network addressing scheme.
Default Settings
The director is delivered with the following default network addresses:
• MAC address—The Media Access Control (MAC) address is programmed into
FLASH memory on the CTP2 card at the time of manufacture. The address is in
xx.xx.xx.xx.xx.xx format, where xx is a hexadecimal pair.
• IP address—The factory preset, default IP address is 10.1.1.10.
If the Reset Configuration option is selected from HAFM, the director resets to the
default address of 10.1.1.10.
NOTE: If multiple directors are installed on the same LAN, each director (and server) must
use a unique IP address. One director can use the factory-set address, but the addresses
of the remaining directors require change.
• Subnet mask—The subnet mask is 255.0.0.0. If the director is installed on a
complex public LAN with one or more routers, the address may require change.
• Gateway address—The gateway address is 0.0.0.0. If the director is installed on a
dedicated LAN with no connection through a router, the address does not require
change. If the director is installed on a public LAN (corporate intranet), the
gateway address must be changed to the address of the corporate intranet’s local
router.
Verify the type of LAN installation with the customer’s network administrator. If one
director is installed on a dedicated LAN, network addresses must be verified but do
not require change.