director 2/64 installation guide

2–32 director 2/64 installation guide
Installing and Configuring the Director 2/64
Changing the Director’s IP Address
If multiple directors are installed, or a public LAN segment is used, network addresses
must be changed to conform to the customer’s LAN addressing scheme. The
following items are required to perform this task.
• A local workstation (desktop or notebook computer) with:
— Microsoft Windows 98, Windows 2000, Windows XP, or Windows NT 4.0
operating system.
— RS-232 serial communication software (for example, ProComm Plus or
HyperTerminal)
Note that the HAFM server may be used for this function and that HyperTerminal
is included in Windows 2000 provided in the HAFM server.
• An asynchronous RS-232 null modem cable (supplied with the Director 2/64).
Use the following steps to verify or change (if required) a director IP address, subnet
mask, or gateway address:
1. Remove the protective cap from the 9-pin maintenance port at the rear of the
director (a flat-tip screwdriver may be required). See Figure 2–22 1.