director 2/64 installation guide

2–34 director 2/64 installation guide
Installing and Configuring the Director 2/64
4. Power on the workstation and establish a connection to the director using
Windows HyperTerminal.
5. Configure the Port Settings parameters as follows:
• Bits per second: 57600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: Hardware
6. Click OK. The HyperTerminal window displays.
7. At the > prompt, type the user-level password (the default is password) and press
the Enter key. The password is case sensitive. The HyperTerminal window
displays with an C> prompt at the top of the window.
8. At the C> prompt, type ipconfig and press Enter. The HyperTerminal
window displays, as shown in Figure 2–23.
•MAC Address
• IP Address (default is 10.1.1.10)
• Subnet Mask (default is 255.0.0.0)
• Gateway Address (default is 0.0.0.0)
Only the IP Address, Subnet Mask, and Gateway Address fields are
configurable.