director 2/64 installation guide

2–36 director 2/64 installation guide
Installing and Configuring the Director 2/64
LAN-Connect the Director
Use these steps to connect the rack-mounted director to the Ethernet LAN segment.
1. Connect one end of an Ethernet cable to the RJ-45 connector on each CTP2 card,
as shown in Figure 2–24.
Figure 2–24: LAN-connect the director
2. Connect the remaining end of each Ethernet cable to the LAN as directed by the
customer’s network administrator.
NOTE: If an HAFM server is not available, use the Embedded Web Server (EWS)
interface. Attach the Ethernet LAN segment to an Internet connection and see Chapter 3.
HAFM Server
To run HAFM software, you must set up and configure the HP laptop server PC to
function as an HAFM server.
Refer to the hp StorageWorks HAFM server installation guide for instructions on:
1 Remote workstation
2 Ethernet hub or switch (customer
supplied)
3 HAFM server
4 Director 2/64