director 2/64 installation guide

director 2/64 installation guide 2–41
Installing and Configuring the Director 2/64
3. Set director date and time manually, or set for periodic updates. For specific
instructions, see the following sections:
• Set Director Date and Time, page 2–40
• Synchronize Date and Time, page 2–42
Figure 2–28: Configure Date and Time dialog box
Set Date and Time Manually
Use these steps to set the director date and time manually.
1. At the Configure Date and Time dialog box, click the Periodic Date/Time
Synchronization check box to deselect the option (no check mark in the box).
The greyed-out Date and Time fields activate.
2. Click the Date fields that require change, and type numbers in the following
ranges:
Month (MM): 1 through 12
Day (DD): 1 through 31
Year (YYYY): greater than 1980
3. Click the Time fields that require change, and type numbers in the following
ranges:
Hour (HH): 0 through 23
Minute (MM): 0 through 59
Second (SS): 0 through 59
4. Click Activate to set the director date and time, and close the Configure Date
and Time dialog box.