director 2/64 installation guide

2–42 director 2/64 installation guide
Installing and Configuring the Director 2/64
Synchronize Date and Time
Use these steps to set the director to periodically synchronize date and time with
HAFM.
1. At the Configure Date and Time dialog box, choose the Periodic Date/Time
Synchronization check box. The Date and Time fields are greyed-out and not
selectable.
2. Click Activate to enable synchronization and close the Configure Date and
Time dialog box. The director date and time synchronize with the HAFM date and
time at the next update period (at least once daily).
3. Click Sync Now to synchronize the director and HAFM immediately. The Date
and Time Synced dialog box displays.
4. Click OK.
5. Click Activate to enable synchronization and close the Configure Date and
Time dialog box.
Frequently Used HAFM Settings
This section summarizes the most common HAFM tasks, including:
NOTE: For a complete reference on HAFM functionality, refer to the hp StorageWorks ha-fabric
manager user guide.
• Set the Director Online, page 2–43
• Set the Director Offline, page 2–43
• Configure Director Identification, page 2–44
• Configuring Switch Operating Parameters, page 2–45
• Configure Fabric Operating Parameters, page 2–48
• Configure Ports (Open Systems Mode), page 2–51
• Configure SNMP Trap Message Recipients, page 2–53
• Configure and Enable E-mail Notification, page 2–54
• Configure and Enable the Proactive Services Call-Home via LAN Feature,
page 2–60
• Test Remote Notification, page 2–61