director 2/64 installation guide

2–44 director 2/64 installation guide
Installing and Configuring the Director 2/64
Configure Director Identification
Perform this procedure to configure the director name, description, location, and
contact person for HAFM. The information displays in multiple dialog boxes
throughout the application. In addition, the Name, Location, and Contact variables
configured in the Configure Identification dialog box correspond respectively to the
SNMP variables sysName, sysLocation, and sysContact. These variables are used by
SNMP management workstations when obtaining data from managed directors.
Follow these steps to configure the director identification.
1. At the Hardware View page, choose Configure > Identification. The Configure
Identification dialog box displays, as shown in Figure 2–29.
Figure 2–29: Configure Identification dialog box
a. Type a director name of 24 or fewer alphanumeric characters in the Name
field. Each director should be configured with a unique name.
If the director is installed on a public LAN, the name should reflect the
director’s Ethernet network DNS host name. For example, if the DNS host
name is SAN64.hp.com, the name entered in this dialog box is SAN64.
b. Type a director description of 255 or fewer alphanumeric characters in the
Description field.
c. Type the director’s physical location (255 or fewer alphanumeric characters)
in the Location field.
d. Type the name of a contact person (255 or fewer alphanumeric characters) in
the Contact field.
2. Click Activate to save the information and close the dialog box.