director 2/64 installation guide

director 2/64 installation guide 2–53
Installing and Configuring the Director 2/64
2. Use the vertical scroll bar as necessary to display additional port information rows
(up to 64 ports).
3. Click Activate to save the configuration information and close the dialog box. If
any port speed was changed, an information message box displays stating, “Port
speed changes will temporarily disrupt port data
transfers. Would you like to continue?” Click Yes to complete
activation.
Configure SNMP Trap Message Recipients
Use this procedure to configure community names, write authorizations, network
addresses, and UDP port number for up to 12 SNMP trap message recipients. A trap
recipient is a management workstation that receives notification through SNMP.
1. At the Hardware View page, choose Configure > SNMP Agent. The Configure
SNMP dialog box displays, as shown in Figure 2–33.
Figure 2–33: Configure SNMP dialog box
a. For each trap recipient to be configured, type a community name of 32 or
fewer alphanumeric characters in the associated Community Name field. The
community name is incorporated in SNMP trap messages to ensure against
unauthorized viewing or use.