director 2/64 installation guide

2–58 director 2/64 installation guide
Installing and Configuring the Director 2/64
Figure 2–38: Ready to create your connection window
7. Enter the name of the connection, and then click the Finish button. The Connect
dialog box displays.
8. Click Dialing Rules. The Phone and Modem Options dialog box displays.
9. Choose a location and click Edit. The Edit Location dialog box displays.
10. Click Calling Card, choose None, and then click OK twice to return to the
Connect dialog box.
11. Unless instructed otherwise, leave the default phone number configured, click
Cancel, and go to step 15.
NOTE: Do not change any configuration defaults for the phone book entry.
12. If instructed by the customer to use a different phone number, click Properties.
13. Change only the Area code and Phone number as instructed.
14. Click OK to close the dialog box, and then click Cancel to close the Connect
dialog box.
15. Verify that the HAFM server’s default IP address is set to 192.168.0.1.
16. If remote dial-in support is not permitted for the installation, see “Test Remote
Notification” on page 2–61 for instructions on testing the LAN-based call-home
feature, if installed.