director 2/64 installation guide

2–68 director 2/64 installation guide
Installing and Configuring the Director 2/64
Modify Alerts
Use the following steps to modify an existing threshold alert configuration.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
Configure Threshold Alerts dialog box displays.
Select the alert that you want to modify by clicking the alert information in the
table. If the alert is active, an error message displays prompting you to deactivate
the alert.
2. If the alert is active, click Deactivate, then choose the alert information in the
table again.
3. Click Modify. An initial Modify Threshold screen displays where you can
change the threshold type.
4. Select a threshold type from the drop-down list.
5. Click Next when you are done. A Modify Threshold screen displays where you
can change the % utilization, cumulative minutes for the threshold to occur before
notification, and the time interval for measuring throughput and for alert
notification.
6. Make appropriate changes, then continue through the Modify Threshold screens,
making changes as necessary, until the summary screen displays the alert
configuration.
7. Perform either of the following steps:
• If you need to change any parameters, click Previous or Next to display the
desired Modify Threshold screen.
• Click Finish when you are done.
Activate or Deactivate Alerts
Use the following steps to activate or deactivate existing threshold alerts. In the active
state, notifications are generated for the alert. In the inactive state, notifications do not
occur.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
Configure Threshold Alerts dialog box displays.
The port’s current state, inactive or active, is listed under the State column.
2. To change the state, choose the alert by the alert information in the table.