director 2/64 installation guide

director 2/64 installation guide 2–69
Installing and Configuring the Director 2/64
3. If the alert is active, choose Deactivate to change to the inactive state. If the alert
is inactive, choose Activate to change to the active state.
Delete Alerts
Use the following steps to delete existing threshold alerts.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
Configure Threshold Alerts dialog box displays.
2. Select the alert that you want to delete by selecting the alert information in the
table and click Delete. A message displays asking you to confirm the deletion.
3. Click Yes. The alert is removed from the dialog box.
Enable Embedded Web Server
Use the following steps to enable EWS:
1. At the Hardware View page, choose Configure > Enable Web Server. Choosing
Enable Web Server automatically places a check mark in the check box.
2. Choose Enable Web Server again to remove the check mark and disable the
EWS interface. When disabled, remote users cannot access the interface.
Enable Telnet
Use the following steps to enable Telnet:
1. At the Hardware View, choose Configure > Enable Telnet. Choosing Enable
Telnet automatically places a check mark in the check box.
2. Choose Enable Telnet again to remove the check mark and disable telnet access.
When disabled, remote users cannot access the director through telnet.
Connect Cables to the Fibre Channel Ports
Use these steps to connect Fibre Channel port cables:
1. Route the fiber-optic cables from customer-specified devices to ports at the front
of the Director 2/64, as shown in Figure 2–46.