director 2/64 service manual

2–104 director 2/64 service manual
Diagnostics
e. In the left pane of the Fabric View window, select the fabric containing the
zone name that was changed. Click the Zone Set tab. Verify that the message
area below the Active Zone Set contains the message “The active zone
set does not currently match the configured zone
set.”
f. To activate the zone set, click Configure and choose Active Zone Set. The
Active Zone Set dialog box displays. Select the zone to be activated and click
Next.
g. The new display summarizes the zone member changes that will be made by
activating the new zone set. Click Next if this reflects the desired zone
change.
h. The new display summarizes the directors and switches that will be affected
by activating the new zone set. Click Next if this reflects the desired zone
change.
i. Click Start to activate the zone set.
Did the zone name change solve the problem and did both directors join through the
ISL to form a fabric?
NO YES
↓ The directors, associated ISL, and multiswitch fabric are operational. Exit
MAP.
Contact the next level of support. Exit MAP.
17
A director E_Port segmented because a build fabric protocol error was detected.
1. Disconnect the fiber-optic jumper cable from the segmented E_Port.
2. Reconnect the cable to the same port.
Did disconnecting and reconnecting the cable solve the problem and did both directors
join through the ISL to form a fabric?
NO YES
↓ The directors, associated ISL, and multiswitch fabric are operational. Exit
MAP.