director 2/64 service manual

director 2/64 service manual 2–107
Diagnostics
↓ Analysis for an Ethernet link, AC power distribution, or CTP2 card failure is
not described in this MAP. Go to MAP 0000: Start MAP on page 2–12. If this
is the second time at this step, contact the next level of support. Exit MAP.
23
Inspect the Fibre Channel port segmentation reason at the Embedded Web Server
interface.
1. At the View panel, click the Port Properties tab. The View panel (Port
Properties tab) displays.
2. Click the port number (0 through 63) of the segmented port.
3. Inspect the Segmentation Reason field for the selected port.
Is the Segmentation Reason field blank or does it display an N/A message?
NO YES
↓ The director ISL is operational. Exit MAP.
The Segmentation Reason field displays a message. Table 2–17 lists segmentation
reasons and associated steps that describe fault isolation procedures.
Table 2–17: MAP 700: Segmentation Reasons and Actions
Segmentation Reason Action
Incompatible operating parameters. Go to step 14.
Duplicate domain IDs. Go to step 15.
Incompatible zoning configurations. Go to step 16.
Build fabric protocol error. Go to step 17.
No principal switch. Go to step 19.
No response from attached switch. Go to step 20.
ELP retransmission failure timeout. Go to step 21.