director 2/64 service manual

3–2 director 2/64 service manual
Repair Information
Factory Defaults
Table 3–1 lists the defaults for the passwords, and IP, subnet, and gateway addresses.
Table 3–1: Factory-set Defaults
Procedural Notes
NOTE: HAFM and Product Manager screens in this manual may not match the screens on
your server and workstation. The title bars have been removed and the fields may contain data
that does not match the data seen on your system.
The following procedural notes are referenced in applicable repair procedures. The
notes do not necessarily apply to all procedures in the chapter.
1. Before performing a repair procedure, read the procedure carefully and
thoroughly to familiarize yourself with the information and reduce the possibility
of problems or customer down time.
2. When performing procedures described in this chapter, follow all electrostatic
discharge (ESD) procedures, WARNING and CAUTION statements, and
statements listed in the preface of this manual.
3. After completing steps of a detailed procedure that is referenced from another
procedure, return to the initial (referencing) procedure and continue to the next
step of that procedure.
4. After completing a FRU replacement procedure, extinguish the amber system
error light-emitting diode (LED) on the bezel at the top front of the director.
Item Default
Customer password password
Maintenance password level-2
IP address 10.1.1.10
Subnet mask 255.0.0.0
Gateway address 0.0.0.0