director 2/64 service manual

3–24 director 2/64 service manual
Repair Information
Double-click a port connector to display the Port Properties dialog box, as shown in
Figure 3–13.
Figure 3–13: Port Properties dialog box
The dialog box provides the following information:
• Port Number–The director port number (0 through 63 inclusive).
• Port Name–The user-defined name or description for the port.
• Type–The type of port (G_Port if nothing is attached to the port, F_Port if a
device is attached to the port, and E_Port if the port is connected to another
director or switch as part of an ISL).
• Operating Speed–The operating speed of the port (1 or 2 Gb/sec.).
• Fibre Channel Address–The Fibre Channel address identifier for the port.
• Port WWN–The Fibre Channel WWN for the director port.
• Attached Port WWN–The Fibre Channel WWN for the port of the attached
device.
• Block Configuration–A user-configured state for the port (Blocked or
Unblocked).
• 10-100 km Configuration–A user-specified state for the port (On or Off),
configured through the Configure Ports dialog box.