director 2/64 service manual

3–32 director 2/64 service manual
Repair Information
—The message Port xx: TEST RUNNING displays, where xx is the port
number. If a UPM card is tested, the message displays for all four ports.
— A red progress bar (indicating percent completion) travels from left to right
across the Completion Status field.
As a port is tested, the amber LED flashes (beacons) and the green LED
extinguishes (indicating the port is blocked).
NOTE: Click Stop Test at any time to abort the loopback test.
12. When the test completes, test results display (for each port tested) as Port xx:
Passed! or Port xx: Failed! in the message area of the dialog box. If a
port fails the test, the amber LED for the port remains illuminated.
13. When finished, click Cancel to close the Port Diagnostics dialog box and return
to the Hardware View. Beaconing is disabled for the port or UPM card.
14. Reset each tested port:
a. At the Hardware View, double-click the UPM card for which ports were
tested. The Port Card View displays.
b. At the Port Card View, right-click the tested port. A menu displays.
c. Choose Reset Port. A reset warning box displays.
d. Click OK. The port resets.
External Loopback Test
To perform an external loopback test for a single port or a UPM card (four ports):
1. Notify the customer a disruptive external loopback test will be performed on a
port or UPM card, and the fiber-optic cable or cables will be disconnected. Ensure
the customer’s system administrator quiesces Fibre Channel frame traffic through
the port or UPM card and sets attached devices offline.
NOTE: At the start of the loopback test, the port or UPM card can be online, offline,
blocked, or unblocked.
2. At the HAFM server, open the HAFM application. The Products View displays.
3. Double-click the icon representing the director for which the loopback test will be
performed. The Hardware View for the selected director displays.