director 2/64 service manual

director 2/64 service manual 4–1
4
FRU Removal and Replacement
This chapter describes removal and replacement procedures (RRPs) used by
authorized service representatives for all director field-replaceable units (FRUs). Do
not perform a procedure in this chapter until a failure is isolated to a FRU. If fault
isolation was not performed, go to MAP 0000: Start MAP on page 2–12.
Factory Defaults
Table 4–1 lists the defaults for the passwords, and IP, subnet, and gateway addresses.
Table 4–1: Factory-set Defaults
Procedural Notes
NOTE: HAFM and Product Manager screens in this manual may not match the screens on your
server and workstation. The title bars have been removed and the fields may contain data that
does not match the data seen on your system.
The following procedural notes are referenced as applicable. The notes do not
necessarily apply to all procedures in the chapter.
1. Before performing a FRU repair, read the removal and replacement procedures for
that FRU carefully and thoroughly to familiarize yourself with the procedures and
reduce the possibility of problems or customer down time.
2. When performing procedures described in this chapter, follow all electrostatic
discharge (ESD) procedures, WARNING and CAUTION statements, and
statements listed in the preface of this manual.
Item Default
Customer password password
Maintenance password level-2
IP address 10.1.1.10
Subnet mask 255.0.0.0
Gateway address 0.0.0.0