director 2/64 service manual

4–6 director 2/64 service manual

FRU Removal and Replacement

CAUTION: The torque tool supplied with the director is designed to tighten director

logic cards and is set to release at a torque value of six inch-pounds. Do not use an

Allen wrench or torque tool designed for use with another HP product. Use of the

wrong tool may overtighten and damage logic cards.

a. Insert the torque tool into the locking Allen screw at the bottom of the card.

Turn the screw counterclockwise until the spring releases and the tool turns

freely.

b. Insert the torque tool(1) into the cam Allen screw at the top of the card(2).

To unseat the CTP2 card and cam it out of the backplane, turn the screw

counterclockwise until the tool turns freely, as shown in Figure 4–3.

Figure 4–3: CTP2 card removal and replacement

6. Pull the CTP2 card from its card track and remove it from the director chassis.

Place the card in an antistatic bag to provide ESD protection.

SHR-2286

StorageWorks SAN 6064