director 2/64 service manual

4–14 director 2/64 service manual

FRU Removal and Replacement

5. Disconnect the fiber-optic jumper cable from the port:

a. Pull the keyed LC free from the port’s optical transceiver.

b. Place a protective cap over the cable connector.

6. Depending on the manufacturer, the optical transceiver may have a locking

mechanism to secure the transceiver in the port receptacle, or the transceiver may

have a pull tab to assist in removal.

a. If required, disengage the locking mechanism (usually at the left side of the

transceiver) by squeezing the mechanism or pushing it toward the port

receptacle.

b. Grasp the pull tab or the optical transceiver frame and pull the transceiver (1)

from the port receptacle, as shown in Figure 4–5.

Figure 4–5: SFP optical transceiver removal and replacement

Replacing an SFP Optical Transceiver

To replace an SFP optical transceiver:

1. Remove the transceiver from its packaging.

UPM

SHR-2287