director 2/64 service manual

Cannot show zoning
library. No fabric
exists.
You cannot show the
zoning library if no
fabric exists. You must
have identified a
switch or director to
HAFM for a fabric to
exist.
Identify an existing switch or
director to HAFM using the
New Product dialog box.
Click OK to remove all
contents from log.
This action deletes all
contents from the
selected log.
Click OK to delete the log
contents or Cancel to cancel
the operation.
Connection to HAFM
Server lost.
The connection to the
remote HAFM Server
has been lost.
Log in to the HAFM Server
again through the HAFM
Manager Login dialog box.
Could not export log to
file.
A log file input/output
(I/O) error occurred
and the file could not
be saved to the
specified destination.
The disk may be full or
write protected.
If the disk is full, use another
disk. If the disk is write
protected, change the
write-protect properties or use
another disk.
Default zoning is not
supported in Open
Fabric Mode.
A default zone cannot
be enabled when the
product is enabled for
Open Fabric mode.
Open Fabric mode
does not support zone
members defined by
port numbers.
Redefine zone members by the
WWN of attached devices.
Device is not a
member of a zone in
the active zone set.
The selected device is
not a member of a
zone in the active zone
set and therefore
cannot communicate
with the other device in
the route.
Enable the default zone or
activate a zone set containing
the member before attempting
to show the route.
Table A–1: HAFM Messages (Continued)
Message Description Action