director 2/64 service manual

Are you sure you
want to send
firmware version?
This message
requests confirmation
to send a firmware
version from the
HAFM server’s
firmware library to the
director.
Click Yes to send the
firmware version or No to
abort the operation.
Cannot have spaces
in field.
Spaces are not
allowed as part of the
entry for this field.
Delete spaces from the field
entry.
Cannot install
firmware to a director
with a failed CTP
card.
A firmware version
cannot be installed
on a director with a
failed control
processor (CTP2)
card.
Replace the failed CTP2 card
and retry the firmware
installation.
Cannot Modify
Switch/Director
speed.
Port speeds can not
be configured at a
higher data rate than
the director speed.
This displays when
you set the director
speed to 1 Gb/sec
through the
Configure
Operating
Parameters dialog
box and at least one
of the ports is running
at 2 Gb/sec.
Either return the director
speed to 2 Gb/sec or
configure all port data speeds
to 1 Gb/sec through the
Configure Ports dialog box.
Cannot retrieve
current SNMP
configuration.
The director SNMP
configuration cannot
be retrieved by the
Product Manager
application because
the Ethernet link is
down or busy.
Retry the operation later. If
the condition persists, contact
the next level of support.
Table A–2: Product Manager Messages (Continued)
Message Description Action