director 2/64 service manual

Cannot start data
collection.
The data collection
procedure cannot be
started by the
Product Manager
application because
the Ethernet link is
down or busy.
Retry the operation later. If
the condition persists, contact
the next level of support.
Cannot start firmware
install while CTP
synchronization is in
progress.
The director’s CTP2
cards are
synchronizing and
firmware cannot be
installed until
synchronization is
complete.
Install the firmware after
CTP2 card synchronization
completes.
Cannot start port
diagnostics.
Port diagnostics
cannot be started at
the Product Manager
application because
the Ethernet link is
down or busy.
Retry the operation later. If
the condition persists, contact
the next level of support.
Click OK to remove
all contents from log.
This action deletes all
contents from the
selected log.
Click OK to delete the log
contents or Cancel to cancel
the operation.
Connection to HAFM
server lost. Click OK
to exit application.
The HAFM
application at a
remote workstation
lost the network
connection to the
HAFM server.
Start the HAFM
application to
connect to the HAFM server.
Could not export log
to file.
A log file I/O error
occurred and the file
could not be saved to
the specified
destination. The disk
may be full or write
protected.
If the disk is full, use another
disk. If the disk is write
protected, change the
write-protect properties or use
another disk.
Table A–2: Product Manager Messages (Continued)
Message Description Action