director 2/64 service manual

B–12 director 2/64 service manual
Event Code Tables
Event Code: 071 (continued)
Event Data
(continued):
4 = Build fabric protocol error. A protocol error was detected during incorporation of
the Director 2/64 into the fabric. Disconnect the E_Port link, reconnect the link, and IPL
the director. If the condition persists, perform the data collection procedure and return
the Zip disk to HP support personnel.
5 = No principal switch. No director or switch in the fabric can become the principal
switch. Modify the switch priority to any value other than 255.
6 = No response from attached switch (hello timeout). The Director 2/64 periodically
verifies operation of attached fabric elements (directors or switches). The director
E_Port (at the operational director) times out and segments if the attached device does
not respond. Check the status of the attached director or switch. If the condition persists,
perform the data collection procedure (at the attached device) and return the Zip disk to
HP support personnel.
7 = ELP retransmission failure timeout. A Director 2/64 that exhibits a hardware or
link failure attempted to join a fabric and transmitted multiple ELP frames to a fabric
element (director or switch). However, because of the problem, the director did not
receive responses to the ELP frames, and did not receive an FLOGI frame. After five
ELP transmission attempts, the director E_Port (failed director) times out and segments.
Go to MAP 0000: Start MAP to perform hardware fault isolation at the failed director.
Distribution: Director HAFM Server Host
EWS
Event
Log
System
Error
LED
Event
Log
E-Mail Call
Home
Sense
Info
Link
Incident
✔✔