director 2/64 service manual

2–28 director 2/64 service manual
Diagnostics
NO YES
↓ Failure of both CTP2 cards is indicated. Event codes are not recorded. Go to
MAP 0500: FRU Failure Analysis on page 2–68. Exit MAP.
43
A director-to-PC Internet link problem (Internet too busy or IP address typed
incorrectly) is indicated.
1. Wait approximately five minutes, then attempt to login to the director again.
2. At the Netsite field (Netscape Navigator) or Address field (Internet Explorer),
type http://xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is the IP address of the
director (obtained in step 1). The Username and Password Required dialog box
displays.
3. Type the user name and password obtained in step 1, and click OK. If the View
panel does not display, wait another five minutes and perform this step again.
Is the Embedded Web Server interface operational with the View panel displayed?
YES NO
↓ Perform director fault isolation at the HAFM server. Go to step 3.
44
At the View panel, inspect the Status field.
Does the director status indicate Operational?
NO YES
↓ The director is operational. Exit MAP.
45
Inspect Fibre Channel port operational states.
1. At the View panel, click the Port Properties tab. The View Port Properties panel
displays, as shown in Figure 2–6.
2. Inspect the Beaconing and Operational State fields.