embedded web server user guide

A–10 embedded web server user guide
Error Messages
Error 79: FRU Failed The specified FRU has
failed.
Consult the
installation/service
manual for appropriate
action.
Error 81: Default Zone
Enabled
The request cannot be
completed because the
default zone is enabled
Disable the default zone
and re-submit the
command.
Error 82: Invalid Interop
Mode
The value entered for the
interoperability mode is not
valid.
The interoperability
mode for the Director or
Switch must be mcdata
(Homogenous Fabric) or
open (Open Fabric 1.0).
Make the appropriate
changes and re-submit
the command.
Error 83: Not Allowed in
Open Fabric Mode
This request cannot be
completed while this switch
is operating in Open Fabric
1.0 mode.
Configure the interop
mode to Homogenous
Fabric mode.
Error 88: Invalid
Feature Key Length
The feature key installed is
longer than the maximum
length allowed.
Be sure that the key has
been entered correctly
and re-submit. Contact
your sales representative
with any further
problems.
Error 89: Not Allowed in
S/390 Mode Without
the SANtegrity Feature
Cannot configure port types
in S/390 mode without
installing SANtegrity.
This command is only
supported when the
switch is in Open
Systems mode or in
S/390 with SANtegrity.
Error 90: Invalid Port
Typ e
The port type configured is
invalid.
A port may be configured
to be an eport, gport, or
fport. Be sure the port is
configured appropriately
and re-submit the
command.
Message Description Action