embedded web server user guide

6–4 embedded web server user guide
Operating and Managing Products and Parts
Resetting Product Configuration to Default Values
Choose Operations from the navigation panel. Choose the Switch or Director tab as
appropriate. Choose the Reset Config tab; the Reset Config tab view displays
(Figure 6–3). You can use this view to reset product configuration values. This enables
you to reset all configuration data and nonvolatile settings to the factory default values
including any data that was created from the Configure page and associated tabs.
Figure 6–3: Resetting product to default values
NOTE: You may be asked to perform this operation by service personnel; it is important to
review the information in this section before performing this operation.
For a list of factory default values, refer to the product’s installation and service
manual.
CAUTION: This operation will reset all configuration data and non-volatile settings to
the factory default values. All optional features will also be disabled. You will need to
activate optional features after completing the product reset.
NOTE: Before resetting the product, you may want to review the kinds of data that will be reset
by browsing through the Configure page and associated tabs.