958-000289-001, June 2003)

Installing and Configuring the Director 2/64

57Director 2/64 Installation Guide

9. Connect the equipment rack power cords to separate (for redundancy) facility

power sources, providing single-phase, 120 to 240 VAC current.

Figure 14: AC power connections

HP System/e and Industry-Standard 19-in Rack Installation

To install the director in a HP system/e or industry-standard 19-in rack, complete

the procedures in the following sections:

■ Install the Anti-tip Feet on a HP System/e Rack, page 57

■ Install Mounting Bracket Hardware in the Rack, page 58

■ Prepare the Front and Rear Rack Columns, page 62

■ Prepare the Switch for Installation, page 63

■ Finalize the Rack Mounting Procedure, page 65

■ Sliding Shelf Installation—For an HAFM Server only, page 67

■ Recommended Cable Management, page 70

Install the Anti-tip Feet on a HP System/e Rack

Use the following procedure to mount anti-tip feet on a HP system/e rack only, as

shown in Figure 15:

1. Place the anti-tip feet (1), provided in the HP system/e and industry-standard

19-in rack mount kits on the front and rear of the rack base.

2. Secure the anti-tip feet (1) to the base of the rack (front and rear).