958-000289-001, June 2003)

Installing and Configuring the Director 2/64

63Director 2/64 Installation Guide

Note: Two sheet metal nuts should be on each back column face (3).

Figure 21: Preparing the rear rack columns

Prepare the Switch for Installation

The following section describes how to install the mounting hardware that

attaches the switch to the rails. This hardware includes:

■ Two front mounting brackets

■ Two rear mounting plates

■ Eight 10-32, flat-head Phillips screws

Use these steps to secure the mounting hardware to the switch, as shown in

Figure 22:

1. Locate the two front mounting brackets in the shipping carton.

2. Position the front mounting bracket (5) so that the bracket’s angled side faces

out and is on the upper part of switch side.