958-000289-001, June 2003)

Installing and Configuring the Director 2/64

74 Director 2/64 Installation Guide

— Microsoft Windows 98, Windows 2000, Windows XP, or Windows NT

4.0 operating system

— RS-232 serial communication software (for example, ProComm Plus or

HyperTerminal)

Note that the HAFM server may be used for this function and that

HyperTerminal is included in Windows 2000 provided in the HAFM server.

■ An asynchronous RS-232 null modem cable (supplied with the Director 2/64)

Use the following steps to verify or change (if required) a director IP address,

subnet mask, or gateway address:

1. Remove the protective cap from the 9-pin maintenance port at the rear of the

director (a flat-tip screwdriver may be required). See Figure 30 1.