FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

HAFM Server Diagnostics

124 HA-Fabric Manager Server Installation Guide

Attempt to clear the problem by rebooting the HAFM server.

1. At the Windows 2000 desktop, click Start at the left side of the task bar

(bottom of the desktop), then select Shut Down. The Shut Down Windows

dialog box displays.

2. Select the Shut Down option from the list box and click OK. The HAFM

server powers down.

3. Wait approximately 30 seconds and press the power button on the LCD panel

to power on the server and perform POSTs. During POSTs:

a. The green LCD panel illuminates.

b. The green HDD LED blinks momentarily, and processor speed and

random-access memory information display momentarily at the LCD

panel.

c. After a few seconds, the LCD panel displays the following message

pertaining to boot sequence selection (Figure 88).

d. Ignore the message. After ten seconds, the server performs the boot

sequence from the BIOS. During the boot sequence, the server performs

additional POSTs and displays the following operational information at

the LCD panel:

—Host name.

— System date and time.

— LAN 1 and LAN 2 IP addresses.

— CPU temperature.

— Hard disk capacity.

— Virtual and physical memory capacity.

4. After successful POST completion, the LCD panel displays a Welcome!!

message, then continuously cycles through and displays server operational

information.

5. After rebooting the server at the LCD panel, log on to the HAFM server’s

Windows 2000 desktop through a LAN connection to a browser-capable PC.

Refer to “Access the HAFM Server Desktop” on page 38 for instructions.The

HAFM Management Services and HAFM applications start and the HAFM