FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Configuration
26 HA-Fabric Manager Server Installation Guide
Configure HAFM Server Password and Network Addresses
Verify the type of LAN installation with the customer’s network administrator. If
the HAFM server or equipment cabinet is installed on a dedicated LAN, network
information does not require change. Change the default password for the server’s
LCD panel (if required by the customer), then go to “Configure HAFM Server
Information” on page 38.
If the HAFM server or equipment cabinet is installed on a public LAN segment,
the default password for the server’s LCD panel and the following transmission
control protocol internet protocol (TCP/IP) network information must be changed
to conform to the customer’s LAN addressing scheme:
■ IP address.
■ Subnet mask.
Note: At some customer installations, TCP/IP addresses for the HAFM server may be
allocated automatically using dynamic host configuration protocol (DHCP).
Configure Password
To configure a new LCD panel password:
1. At the HAFM server’s LCD panel, press ENTER. The Welcome!! or
operational information message changes to the following (Figure 5):
Figure 5: LCD panel (password entry)
2. Using the button to increment a digit, the button to decrement a digit, the
button to move the cursor left, and the button to move the cursor right,
input the default password (9999), and press ENTER. The LAN 1
Setting?? message displays at the LCD panel.
Input Password:
0****